Assembly Instructions

LIGHTING
1. Make sure control knob (2#) is on the “OFF” position on the control panel.
2. Open the access doors. Turn on gas cylinder valve (7#) to fully opened position.
3. Push and turn the control knob (2#) to “HIGH”. (Fig.12)
4. Hold ignitor (3#) to light the burner. Release the control knob (2#) after 45 seconds. (Fig. 13)
5. Adjust flame to desired flame with the control knob (2#). (Fig. 13)
WARNING
Do not operate if there is a kink in the flexible gas hose as this could lead to a gas leak.
WARNING
Lighting the appliance improperly could lead to an unsafe conditions.
Operation
SHUTTING DOWN THE GAS APPLIANCE
1. Turn the gas control knob (2#) to “OFF” to shut down appliance.
2. Turn the gas cylinder valve (7#) off when the gas appliance will not be in
use.
HOW TO DISCONNECT THE CYLINDER
1. Make sure the gas cylinder valve (7#) is fully tightened.
2. Turn the knob (5#) counterclockwise to detach the pressure
regulator (4#) from the cylinder.
3. You can use soap water to check if there is gas leakage at the
outlet.
10