Assembly Instructions
Trouble Shooting
Problem
Observed
Possible Cause Corrective Measures
Gas odor Gas leak
Perform "Leak Check" on page 11.
If odor continues shut off gas supply
and contact your customer service
department.
Delayed ignition
Low gas pressure
Check gas supply pressure.
Clogged or dirty burner ports.
Blocked orifice.
Dead battery.
Check gas supply pressure
Clean burner ports with a wire brush,
Clear orifice opening of any debris.
Replace with a new battery.
Low or
insufficient
burner flame
Low or no gas supply or pressure.
Blocked orifice.
Clogged or dirty burner ports.
Check cylinder gas level and pressure.
Check and clear orifice opening.
Clean burner ports with a wire brush.
Care & Maintenance
To enjoy outstanding performance of your appliance for years, make sure to perform the following maintenance
activities on a regular basis.
• Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use flammable, corrosive or
abrasive cleaners.
• Clean the holes in the burner using a swab that is moistened with soapy water.
• Keep the burner holes unobstructed by using a heavy-duty pipe cleaner. The burner must be dry
before normal use. Clean annually. Compressed air may help clear away smaller particles.
• While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all times.
If the gas control knob (I2) is exposed to water in any way, DO NOT try to use it. It must be replaced.
• After extended non-operation, the unit should be inspected for spiders, spider webs or other insects.
Spider and insects can nest in burner or orifices.
• Air flow must be unobstructed. Keep controls, burner and circulating air passageways clean.
Signs of possible blockage include:
---Gas odor with extreme yellow tipping of flame.
---Gas flow is uneven.
---Burner makes popping noises.
Limited Warranty
Subject to the conditions set out below, this product is warranted to the original purchaser to be free from defects in
workmanship and materials for one year from the date of purchase.
• Dated proof of purchase is required at the time of the warranty claim is submitted.
• This warranty covers all parts found defective in workmanship and / or materials during the warranty period and can be repaired or
have replacement parts sent at the discretion of the manufacturer at no cost to the original purchaser.
• This warranty will be voided if the product has not been assembled, installed or operated according to the instructions, or subjected to
abuse, improperly treated, neglected, rusted by exposure to the elements, misused and/or if any repairs, maintenance, or service
has been done by an unauthorized person.
• If applicable, returns must be properly packaged and returned with freight prepaid to the dealer / retailer from which the product was purchased.
• The manufacturer, distributor and retailer will not be liable for any incidental or consequential loss or damage arising from the installation
or operation of the product and/or the failure of any part or any reason.
• There are no other express or implied warranties, except for those stipulated.
This warranty gives specific rights to the original purchaser. The original purchaser may have additional rights and remedies in state law.
• This warranty does not cover commercial use.
11