Assembly Instructions

• Always place the appliance on a firm and level surface.
• Solid fuels shall not be burned in this gas appliance.
• The appliance shall be used only outdoors in a well-ventilated space and shall not be used
in a building, garage or any other enclosed area.
• When in use, keep the appliance area clear and at least side-40" (101.6cm) and top-72” (182.9cm)
from combustible materials, gasoline and other flammable liquid and vapors.
• Do not use the appliance under combustible surfaces. Certain items or materials, when stored
under the appliance or nearby, will be subjected to radiant heat and could be damaged.
CAUTION • Inspect the hose assembly and burner prior to each use. If there is evidence of excessive
abrasion or wear, or if the hose or burner is damaged, it must be replaced by an appropriate
part from the manufacturer.
• Inspect the gas connections of the appliance prior to each use. Do not operate the unit if there is
a gas leak. Have the appliance inspected annually by a qualified service person.
• The pressure regulator and hose assembly provided with the appliance must be used.
The replacement part must be the same as specified by the manufacturer.
• To attach the LP gas cylinder please refer to the Gas Connection section on page 11 and
perform the leak test on page 15.
• Children and adults should be alerted to the hazards of high surface temperatures and
should stay away to avoid burns or prevent clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
• Clothing or other flammable materials should not be hung from the appliance or placed on
CAUTION or near the appliance.
• Any guard or other protective device removed for servicing the appliance must be replaced
prior to operating the appliance.
• Installation and repair should be done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative that the control compartment, burners,
and circulating air passageways of the appliance are kept clean.
• Do not use the appliance if any part has been under water. Immediately call a qualified
technician to inspect the appliance and to replace any part of the control system and any gas
control which has been under water.
• LP gas supply cylinder to be used must be constructed and marked in accordance with the
specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) See page 13.
CAUTION • The cylinder supplies system must be arranged for vapor withdrawal and the cylinder must
include a collar to protect the cylinder valve.
• Use only 20 lb. (9 kg) LP gas cylinders.
• Do not burn wood or any other materials in this appliance.
• The appliance must be isolated from the gas supply piping system
by closing its individual manual shutoff valve during any pressure
testing of the gas supply piping system at test pressure equal to
or less than 1/2 PSI (3.5 kPa).
• Properly place the hose out of pathways where people may trip over it or in areas
where there may be subject to accidental damage.
• The burner must be replaced prior to the appliance being put into operation if it is evident that
the burner is damaged. The replacement burner must be the same as the part specified by
manufacturer.
• To clean the appliance including the burner, please refer to Care & Maintanence on last page.
• We recommend you not using the gas appliance in strong wind and/or heavy rain.
3