Assembly Instructions

Installation
1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all parts are present before
beginning assembly of products. If any part is missing or damaged, do not attempt to assemble the products. Contact customer
service for replacement parts.
2. Put Burner Cover onto the fire bowl.
3. Open the door, place the gas cylinder into the cylinder holder, connect the regulator, screw the black handle clockwise to tighten.
Turn the black handle counterclockwise to remove. The hose must point down. The knob on the control panel is turned all the way to
the "OFF" position when the fire pit is NOT in use (see Figure 2).
IMPORTANT:
If the knob is not properly threaded to the outlet of the cylinder, gas leak will possibly occur.
4. Secure the cylinder by tightening clockwise the Adjusting Screw found on the cylinder holders (see Figure 3), so that the cylinder
cannot move from side to side or fall down.
5. Inserting the battery:
a. Unscrew the battery box. Insert the negative electrode side of the AAA battery into the bottom of the battery box.
b. Cover the battery with the cover (#3) .
Figure 3
Figure 2
Black handle
8