Assembly Instructions

ManualsBrandsBackyard Creations ManualsOutdoorsCollins Round High Dining Patio Table

TABLE TOP 1 G

METAL

WASHER M6

TABLE LEG 4 H

PLASTIC BOLT

CAP M6

LEG

CONNECTOR

BRACKET 1

1 I

ALLEN

WRENCH

LEG

CONNECTOR

BRACKET 2

1 J

UMBRELLA

CAP

ALLEN BOLT

M6X25MM

FOOT CAP

(FACTORY

ASSEMBLED)

ALLEN BOLT

M6X20MM

Step 3:

Tighten all bolts with the Allen wrench (I). Cover with plastic bolt caps (H).

Step 4:

Carefully turn the table into the upright position. Put the umbrella cap (J) on the table. Your table is now ready for use.

COLLINS HIGH DINING TABLE

SKU # 272-4261

IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!

Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface

to avoid scratching.

IF ANY PARTS ARE MISSING OR DAMAGED, DO NOT ATTEMPT TO ASSEMBLE OR RETURN TO THE STORE.

Please contact our customer service center (Monday-Friday 8:30 a.m.- 4:30 p.m. CST) at 1-800-426-2950 or e-mail:

cs@patiohelpdesk.com.

PARTS LIST

Step 1:

IMPORTANT NOTE: At least two people are needed to carefully lift the table.

Place the table top (A) upside down on a flat, soft surface. Attach the table leg (B) to the table top (A) using eight bolts (E) and

metal washers (G). Insert bolt (E) into each hole on the leg and into the table top. DO NOT TIGHTEN COMPLETELY.

Step 2:

Attach the two leg connector brackets (C&D) to each table leg using eight bolts (F) with metal washers (G) through each hole

on the connector brackets and table legs. Bolts remain loose until both brackets are attached. IMPORTANT NOTE: Each bolt

should be tightened a few revolutions at a time, alternating between bolts in a cross corner (X) pattern to ensure your table is

level. Do not over tighten.

Summary of content (2 pages)

PAGE 1
COLLINS HIGH DINING TABLE SKU # 272-4261 IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY! Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid scratching. IF ANY PARTS ARE MISSING OR DAMAGED, DO NOT ATTEMPT TO ASSEMBLE OR RETURN TO THE STORE. Please contact our customer service center (Monday-Friday 8:30 a.m.- 4:30 p.m. CST) at 1-800-426-2950 or e-mail: cs@patiohelpdesk.com.
PAGE 2
IMPORTANT: To avoid damage to your table: ● An umbrella base must be used at all times. ● If applicable, make sure the plastic umbrella safety ring is installed in the center of the table before you insert the umbrella pole through the table. ● Remove umbrella from the table when not in use or in the event of wind, rain, hail, sleet, snow or any other inclement weather. ● In storing patio furniture, do not stack anything on glass, stone or marble table tops.