Assembly Instructions

2018
GLENN BROOK
BALCONY SWIVEL CHAIR
Step 1
Attach the triangular T-rock (C) to the chair frame (A) using two rectangular steel plates (I), four
bolts (G), four nuts (E) and lock washers (D) in order of hex bolts, rectangular steel plate, chair
cross bar, triangular t-rock, lock washer and nut. NOTE: Bolts are inserted from underneath the
seat (closest to the seat fabric or straps) through the crossbar and into the T-rock. Tighten all
the bolts (G) and nuts (H) using hex wrench (J). Cover all the bolts and nuts with the plastic bolt
and nut caps (F&H)
Step 2
Insert the shaft of the T-rock directly into the plastic bushing of the chair base (B). Make sure
you have inserted it all the way and that the base is locked onto the shaft. Your chair is now
ready for use.
PARTS LIST
A
CHAIR
FRAME
1
F
PLASTIC BOLT
CAP M8
4
B
CHAIR BASE
1
G
HEX BOLT
M8x38mm
4
C
TRIANGULAR
T-ROCK
1
H
PLASTIC NUT CAP
M8
4
D
LOCK
WASHER
4
I
RECTANGULAR
STEEL PLATE
2
E
NUT M8
4
J
HEX WRENCH
2
IMPORTANT:
• Before storing, drain all water that may have accumulated in or around the frames.
• If not drained properly, water can cause freeze damage.
• Cover furniture with outdoor furniture covers when not in use.
A
B
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective materials, place
parts on a nonabrasive surface to avoid scratching. If any parts are missing or damaged, DO NOT
attempt to assemble. Please contact our customer service center (Monday-Friday 9:00 a.m.-5:00
p.m. CST) at 1-877-931-7378 (fax: [phone]), or e-mail: [e-mail].