Assembly Instructions

HAMILTON
HIGH DINING TABLE
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective materials,
place parts on a nonabrasive surface to avoid scratching. If any parts are missing or
damaged, DO NOT attempt to assemble. Please contact our customer service center
(Monday-Friday 9:00 a.m.-5:00 p.m. CST) at 1-877-931-7378 (fax: [phone]), or e-mail:
[e-mail].
Step 1
IMPORTANT NOTE: At least two people are needed to carefully lift the table.
Place the table top (A) upside down on a flat, soft surface. Attach the table leg (B) to the
table top (A) using eight bolts (E) and metal washers (G). Insert bolt (E) into each hole on
the leg and into the table top. DO NOT TIGHTEN COMPLETELY.
Step 2
Attach the two leg connector brackets (C&D) to each table leg using eight bolts (F) with
metal washers (G) through each hole on the connector brackets and table legs. Bolts remain
loose until both brackets are attached. IMPORTANT NOTE: Each bolt should be tightened a
few revolutions at a time, alternating between bolts in a cross corner (X) pattern to ensure
your table is level. Do not over tighten.
Step 3
Tighten all bolts with the Allen wrench (I). Cover with plastic bolt caps (H).
Step 4
Carefully turn the table into the upright position. Your table is now ready for use.
IMPORTANT: To avoid damage to your table:
• An umbrella base must be used at all times.
• If applicable, make sure the plastic umbrella safety ring is installed in the center of
the table before you insert the umbrella pole through the table.
• Remove umbrella from the table when not in use or in the event of wind, rain, hail,
sleet, snow or any other inclement weather.
• In storing patio furniture, do not stack anything on glass, stone or marble tabletops.
• Before storing, drain all water that may have accumulated in or around table frame.
If not drained properly, water can cause freeze damage.
• Cover furniture with outdoor furniture covers when not in use.
• For safety reasons, do not sit or stand on the table.
PARTS LIST
A
TABLE TOP
1
F
ALLEN BOLT
M6x20mm
8
B
TABLE LEG
4
G
METAL
WASHER
M6
16
C
LEG
CONNECTOR
BRACKET 1
1
H
PLASTIC
BOLT CAP
M6
16
D
LEG
CONNECTOR
BRACKET 2
1
I
ALLEN
WRENCH
1
E
ALLEN BOLT
M6x25mm
8
J
UMBRELLA
CAP
1
2018
G F H
H
E
G
J