Assembly Instructions

ManualsBrandsBackyard Creations ManualsOutdoorsTanner Falls Patio Club Rocker - 2 Pack

LEFT ARM

1 DD

PLASTIC BOLT CAP

RIGHT ARM

1 EE

HEX BOLT

M8X45MM

BACK

1 FF

METAL WASHER M8

SEAT

1 GG

LOCK WASHER

BASE

1 HH

PLASTIC BOLT CAP

T-ROCKER

1 II

PLASTIC NUT CAP

RECTANGULAR

STEEL PLATE

4 JJ

NUT M8

BACK CUSHION

1 KK

HEX WRENCH

SEAT CUSHION

1 LL

ALLEN WRENCH

ALLEN BOLT

M6X45MM

ROCKER PLATE

(FACTORY

ASSEMBLED)

ALLEN BOLT

M6X15MM

PLASTIC RING ON

CHAIR BASE

(FACTORY

ASSEMBLED)

METAL

WASHER M6

SELF TAPPING

SCREW ON CHAIR

BASE (FACTORY

ASSEMBLED)

IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!

Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid scratching.

IF ANY PARTS ARE MISSING OR DAMAGED, DO NOT ATTEMPT TO ASSEMBLE OR RETURN TO THE STORE.

Please contact our customer service center (Monday-Friday 8:30 a.m.- 4:30 p.m. CST) at 1-800-426-2950 or e-mail: cs@patiohelpdesk.com.

PARTS LIST

TANNER FALLS CLUB ROCKER - 2PK

SKU # 272-5183

Step 1:

Attach the left arm (A) and right arm (B) to the back (C) using two M6X15mm allen bolts (BB) and two metal

washers (CC) at the top and two M6X45mm allen bolts (AA) and two metal washers (CC) at the bottom. Do not

tighten the bolts until assembly is complete.

Step 2:

Attach the seat (D) to the back (C) using four M6X15mm allen bolts (BB) and four metal washers (CC) at the front and two

M6X45mm allen bolts (AA) and two metal washers (CC) at the back. Tighten all the bolts by using the allen wrench (LL) and cover

all the bolts with bolt caps (DD).

Summary of content (2 pages)

PAGE 1
TANNER FALLS CLUB ROCKER - 2PK SKU # 272-5183 IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY! Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid scratching. IF ANY PARTS ARE MISSING OR DAMAGED, DO NOT ATTEMPT TO ASSEMBLE OR RETURN TO THE STORE. Please contact our customer service center (Monday-Friday 8:30 a.m.- 4:30 p.m. CST) at 1-800-426-2950 or e-mail: cs@patiohelpdesk.com.
PAGE 2
Step 5: Put the seat cushion (I) and back cushion (H) in the chair frame. Your chair should be ready for use. Step 3: A. Attach the T-Rocker (F) to the finished frame with four M8X45mm hex bolts in the order of bolts (EE), four M8 washers (FF), four If your chair is not rocking properly, double-check your assembly procedure, especially rectangular steel plates (G), four M8 washers (FF), four lock washers (GG) and four M8 nuts (JJ). Tighten all the bolts using two step 3.