Assembly Instructions

● Before storing, drain all water that may have accumulated in or around the frames.
● If not drained properly, water can cause freeze damage.
● Cover furniture with outdoor furniture covers when not in use.
Step 4: Turn over the chair frame. Place the finished frame into the chair base (E) by inserting the shaft directly into the plastic
bushing of the chair base. Use a twisting motion if necessary. Make sure you have inserted it all the way and that the base is locked
onto the shaft.
IMPORTANT:
Step 5: Put the seat cushion (I) and back cushion (H) in the chair frame. Your chair should be ready
for use.
Step 3:
A. Attach the T-Rocker (F) to the finished frame with four M8X45mm hex bolts in the order of bolts (EE), four M8 washers (FF), four
rectangular steel plates (G), four M8 washers (FF), four lock washers (GG) and four M8 nuts (JJ). Tighten all the bolts using two
hex wrenches (KK). Cover the bolts and nuts with bolt caps (HH) and nut caps (II).
If your chair is not rocking properly, double-check your assembly procedure, especially
step 3. If the chair rocks too far forward or is difficult to rock backwards, you probably
installed the seat frame backwards on the rocker assembly. If you need further assistance,
please call our Customer Service Center at 1-800-426-2950 or e-mail:
[e-mail].