Stackstone Fire Table ITM./ART.#: 2595161 MODEL#: F180072 ANS Z21.97/CSA 2.41-2014 Outdoor Decorative Gas Appliances Installer: Leave these instructions with consumer. Consumer: Keep these instructions for further reference.
IMPORTANT SAFETY INFORMATION 1. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1●NFPA 54; National Fuel Gas Code; Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code, CSA B149.2, as applicable. 2.
IMPORTANT SAFETY INFORMATION ABOUT PROPANE (LP) GAS 1. The LP-gas supply cylinder to be used must be constructed and marked in accordance with the U.S. Deparment of Transportation (D.O.T.) Specifications for LP-Gas Cylinders, or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable. 2. The LP-gas supply cylinder to be used must have a listed overfilling prevention device (See Figure 1). 3.
PACKAGE CONTENTS A F B E C D PART A B C D E F DESCRIPTION Fire table Door Lid Weather cover Natural gas orifice Lava rock (13.2 Ibs) QUANTITY 1 pc 1 pc 1 pc 1 pc 1 pc 2 box ASSEMBLY INSTRUCTIONS 1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all parts are present before beginning assembly of product. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. 2.
black handle Figure 4 Figure 3 4. Attach the door (B) with fire table (A) tenderly (see Figure 5). Place the Lid (C) onto the fire bowl when not in use to protect it from the elements or when fire pit is cool COMPLETELY after the use (see Figure 6). C A B Figure 5 Figure 6 5. Cover the fire pit with the outdoor Weather cover (D) when not in use to protect it from the elements or when fire pit is cool COMPLETELY after the use (see Figure 7).
STOP NATURAL GAS CONVERSION STOP Natural gas conversion must be performed only by natural gas provider or service company. 1. Disconnect the propane hose from the gas valve (see Figure 8). gas valve propane hose Figure 8 2. Unscrew and disconnect the propane orifice from the bellows (see Figure 9). Propane orifice (dia2.21mm size) is painted with red mark. propane orifice bellows propane orifice bellows Figure 9 3.
4. Connect the natural gas hose with the gas valve by screwing clockwise tightly (see Figure 11). Plug the natural gas fixture into the natrual gas supply piping system (see Figure 12). gas valve natrual gas supply piping system natrual gas fixture natural gas hose Figure 11 Figure 12 5. Stick and cover the conversion label onto the propane rating plate (see Figure 13). Serial Number: CAUTION: This appliance has been converted to use natural gas. Propane orifice dia2.21mm, natural gas orifice dia4.
BATTERY Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the control panel to access the battery compartment. The ignitor module requires one AAA size battery. BATTERY IS NOT INCLUDED. (see Figure 14). WARNING: 1. Please observe proper polarity and use the correct battery type when placing or replacing the battery. Improper installation could result in ignition failure. 2.
inlet tube-bellows connection (Figure 18) gas valve-hose connection (Figure 17) To perform a leak test: 1. Make 2~3 oz. of leak solution by mixing one part liquid dishwashing detergent and three parts water. Noted: make sure control knob is “OFF”. 2. Apply several drops of solution where the cylinder attaches to regulator (see Figure 15), inspect the solution at the connection looking for bubbles. If NO bubbles appear, the connection is secure.
Observe Flame Height When Lit: Flame should be a blue / yellow color between 1~2 in. height (see Figure 20). Bad Good Figure 20 CARE AND MAINTENANCE To enjoy the outstanding performance from your fire pit, make sure you perform the following activities on a regular basis: 1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents. 2. While cleaning the fire pit, make sure to keep the area around the burner dry at all times. DO NOT submerge the control valve assembly.
WARRANTY Firepits Burner, steel fire pit bowl, all mechanical parts and fittings to control panel and burner assembly, and all fire pit tops that are not cast aluminum are warranted for a period of one (1) year from original date of purchase, against defects in material and or workmanship. Rust is not covered. Frames Frames are warranted to be free from defects in materials and workmanship for a period of one (1) year.
