Instructions / Assembly
Positioning Your Playcenter
• The playcenter is designed to be installed on a level
surface by an adult with an adult helper. Place in a at
area of your yard to minimize ground preparation.
• Choose a level location for the equipment. This can
reduce the likelihood of the play set tipping over
and loose fill surfacing material washing away
during heavy rains.
• Place the equipment not less than 6'-7" (2.0 m) from
any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry lines, or
electrical wires.
• Provide enough room so that the children can use
the equipment safely. For example, for structures
with multiple play activities, a slide should not exit
in front of a swing.
• It is a good idea to place your playcenter in an area
that is convenient for adults to watch children at
play.
• Create a site free of obstacles that could cause injuries
– such as low overhanging tree branches, overhead
wires, tree stumps and/or roots, large rocks, bricks and
concrete. Additional suggestions in the Suggested
Playground Surfacing Section.
• Do not build your play set on top of surfacing material.
• Locate bare metal platforms and slides out of direct
sunlight to reduce the likelihood of serious burns. A
slide that faces north will receive the least direct
sunlight.
• Separate active and quiet activities from each other.
For example, locate sandboxes away from swings or
use a guardrail or barrier to separate the sandbox
from the movement of the swings.
Suggested Playground Surfacing
The following chart explains the fall height in feet from which a life threatening head injury would not be expected
Critical Heights in feet (m) of Tested Materials
Material Compressed Depth
6" (152mm) 9" (228mm) 12" (304mm) to 9" (228mm)
Wood Chips
7' (2.13m) 10-12' (3.0-3.6m) 11' (3.35m) 10' (3.05m)
Double-Shredded Bark Mulch
6' (1.83m) 10-12' (3.0-3.6m) 11' (3.35m) 7' (2.13m)
Engineered Wood Fibers
6' (1.83m) 7' (2.13m) >12' (3.66m) 6' (1.83m)
Fine Sand
5' (1.52m) 5' (1.52m) 9' (2.74m) 5' (1.52m)
Coarse Sand
5' (1.52m) 5' (1.52m) 6' (1.83m) 4' (1.22m)
Fine Gravel
5' (1.52m) 7' (2.13m) 10' (3.05m) 6' (1.83m)
Medium Gravel
5' (1.52m) 5' (1.52m) 6' (1.83m) 5' (1.52m)
Shredded Tires*
10-12' (3.0-3.6m) N/A N/A N/A
Uncompressed Depth
*This data is from tests conducted by independent testing laboratories on a 6-inch depth of uncompressed shredded tire samples produced by four manufacturers. The tests reported
critical heights, which varied from 10 feet to greater than 12 feet. It is recommended that persons seeking to install shredded tires as a protective surface request test
data from the supplier showing the critical height of the material when it was tested in accordance with ASTM F1292.
Please
Read This
Before
Starting
Assembly
Owner’s Manual Play Set
• Do not install home playground equipment over
concrete, asphalt, packed earth, grass, carpet, or any
other hard surface. A fall onto a hard surface can
result in serious injury to the equipment user.
• Do not install loose ll surfacing over hard surfaces
such as concrete or asphalt.
• Shredded bark mulch, wood chips, fine sand and
gravel, are added as shock absorbing materials after
assembly. If used properly these materials can
absorb some of the impact of a child’s fall.
• All surface material should extend a minimum of
6'-7" (2.0 m) feet in all directions around the play
area.
• Do not apply playground surfacing until after the
unit is completely constructed. Play set should not
be built on top of surfacing.
• Use containment, such as digging out around
the perimeter and/or lining the perimeter with
landscape edging.
• Installations of rubber tiles or poured-in-place
surfaces (other than loose fill materials) generally
require a professional and are not “do-it-yourself”
projects.
• Shall use Playground Surfacing Materials (other
than loose fill material) which comply with the
safety standard ASTM F1292 Standard specification
of Impact Attenuation of Surfacing Materials within
the Use Zone of Playground Equipment.
• Anchors shall be placed as instructed to reduce
tipping hazards.
6