Instructions / Assembly

Phase Notes
• Assemble with hardware as shown.
Fort Assembly
Phase 10
Parts needed:
• (6) M10 - FORT RAIL - W101190
Hardware needed:
• (24) BR - SCREW PFH 8x1-1/8 - H100088
Step 1:
Pre-drill & attach
'M10' Fort Rail to 'K5' fort
rail and 'M4' wall rail using
Screws 'BR', as shown.
BR
M10
K5
BR
M4
2 3/4"
1
9
/
1
6
1
9
/
1
6
K6
M4
K5
M10
Note: Due to the changing size of the wood
as a result of moisture content, you may
need to adjust the spacing of your wall slats
1/16" to 1/8" when assembling walls. It would
be best to line up the boards on the wall
before attaching to estimate if a larger or
smaller gap is needed.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
Note: It is vital that the fort
be level before and after
each phase of assembly.
Note:
Do not overtighten screws, overtightening
may cause the screw to stick through the boards
and may cause sharp points. The head of the
screw should NOT sink into the wood for this
phase, it should be flush.
1 11/16"
1 11/16"