Instructions / Assembly

Anchoring Instructions
Phase 27
Phase Notes
• Assemble with hardware as shown.
• Install the screw into the upright so that the
tip of the screw does not stick through. Make
sure you have enough wood to accommodate
the screw before installing.
• FAILURE TO USE STAKES CAN VOID
WARRANTY & CAUSE INJURY!
Parts needed:
• (8) KD - PLASTIC GROUND STAKE BROWN - A100179
• (2) FB - SWING SEAT YELLOW - A100070
• (8) FA - QUICK LINK - A100069
• (4) EZ - CHAIN GREEN 51.25" - A100068
• GLIDER ASSEMBLY
• (4) JD - CHAIN GREEN 45" - A100092
Hardware needed:
• (8) BQ - SCREW PFH 8x1-1/4 - H100087
Step 2:
Attach Swing Seats 'FB' to
swing beam using Quick Clip 'FA' and
Chain 'EZ'.
*Stakes should be placed in concrete*
Step 3: Attach Glider Assembly to
swing beam using Quick Clip 'FA' and
Chain 'JD'.
Final Step:
Double check and make sure
every bolt, screw and nut is tight. Make
sure every board is secure. Make sure
the fort is level and enjoy your swing set.
STAKE
STAKE
STAKE
STAKE
STAKE
STAKE
STAKE
STAKE
SWING
SWING
Step 1: Drive Stakes ' ' into the ground
against boards where shown and attach
with Screws ' ', as shown.
KD
K1
BQ
KD
BQ
TIGHTEN QUICK
LINK
INSERT CHAIN INTO
QUICK LINK