Installation Guide

Bamboo Fencing Installation

Installation on Existing Chain Link Fence

Required tools/materials:

Pliers, Diagonal Cutter, Tie Wire (14-16 gauge galvanized)

1) Have helper straighten out the bamboo roll to eliminate any kinks.

2) Have helper hold bamboo roll against chain link fence to ensure that

bamboo roll is level and one inch above the ground. (helpful hint- set

bamboo on top of one inch thick scrap piece of lumber)

3) Attach bamboo roll to chain link fence with galvanized steel tie wire

every twelve inches altering top to bottom. Make sure that the fence is

straight and level. Trim excess wire

4) Enjoy your beautiful, tropical, eco-friendly bamboo fence!

Installation on Block/Brick Wall

Required tools/materials:

Cordless drill, 2x4 treated lumber for horizontal rails. Powder actuated

tool with proper load and nail, or tapcon system (to attach rails),desk

screws, tapered drill bit with countersink attachment

1) Attach 2x4 near top and bottom of wall utilizing either your PAT, or

tapcon system. Make sure the horizontal rail is level and flush with the

wall (remove excess mortar prior to installation

2) Have helper hold flattened bamboo roll against horizontal rails. Pre-drill

the bamboo poles with a drill bit slightly smaller than the diameter of the

deck screw (this protects the bamboo from cracking or splitting). Fasten

bamboo roll onto horizontal tails at 12'' increments. Alternate top to

keep fence straight and level.

3) Enjoy your beautiful, tropical, eco-friendly bamboo fence!

Installation on Existing Wooden Fence

Required tools/materials:

Cordless drill, level, Wood Screws (2''-2 ½''). Tapered drill bit w/

countersink attach

1) Check that existing wood posts are secure and free of rot

2) Have helper hold flattened bamboo roll against either side of the existing

fence. Raise bamboo roll 1'' above ground level if necessary (alleviates

soaking up moisture)

3) Pre-drill bamboo poles, then attach bamboo roll beginning at either top

corner of existing fence (you can attach it to either the 2x4 or the wood

fence panel)

4) Alternate top to bottom every 12''

5) Enjoy your beautiful, tropical, eco-friendly bamboo fence!

New Fence Construction

Required tools/materials:

Cordless Drill, Level, Tapered drill bit with countersink attachment

4'x4' treated lumber (fir or redwood for posts)

PAGE 1
Bamboo Fencing Installation Installation on Existing Chain Link Fence Required tools/materials: Pliers, Diagonal Cutter, Tie Wire (14-16 gauge galvanized) 1) Have helper straighten out the bamboo roll to eliminate any kinks. 2) Have helper hold bamboo roll against chain link fence to ensure that bamboo roll is level and one inch above the ground.
PAGE 2
1) 2) 3) 4) 5) 2'x2' treated lumber (fir or redwood for posts) 1''x4' treated lumber for horizontal trim 2'x6' treated lumber for top cap 2'' deck screws- use contemporary color Dig holes 6' apart and at least 18-24'' deep. Insert 4' x 4' post into holes and fill with concrete. Make sure post is plumb and level and 6''1'' inside diameter from post to post. Install horizontal rails neat the top and bottom of the posts (6-12''). Make sure the horizontal rails are flush with the back of the 4'x4' post.