Use and Care Manual

www.BackyardXScapes.com
“Helping Create a New Paradise Everyday”
ONLY USE THESE SEALERS
AMTECO TOTAL WOOD PROTECTION 300 SERIES (www.usetwp.com)
CABOT AUSTRIALIAN TIMBER OIL 19000 SERIES (www.cabotstains.com)
PRODUCT DESCRIPTION: A high performance, high solids, exterior wood finish, which may be applied to
obtain a stained or high build, deep gloss finish, depending on application procedures. The transparent
natural wood tone finishes supplement and enhance the natural beauty o the woods grain and color.
The cured finish has superior UV, water and abrasion resistance. The finish is also extremely resistant to
attack from mildew and wood destroying organisms. Although the product exhibits excellent
penetration on new and old wood, the cured finish is very resistant to airborne contamination and
moisture due to its positive dry nature.
PRODUCT USES: Perfect for old or new decks, outdoor furniture, spas, picnic tables, benches, bamboo,
playground equipment, decks, gazebos, shutters, doors, windows, and boats (teak).
SURFACE PREPARATION
NEW WOOD: Sand wood smooth with 150 grit sandpaper or pad to open grain. Rinse surface with 4:1
mix of water and household bleach or wood bleach (best for enhanced color). Rinse thoroughly with
water and allow a minimum of 48 hours of good drying conditions before applying sealer.
OLD WOOD: Rinse surface with 3:1 mix of water and household bleach to remove mildew; use wood
bleach to brighten wood and follow with 1500 p.s.i. power washer to remove dead surface fiber. Allow a
minimum of 48 hours of good drying conditions before applying sealer.
PREVIOUSLY STAINED WOOD: Remove all of the old finish with power washer or paint stripper when
necessary. Failure to remove the existing finish will result in a blotchy application due to uneven
penetration and discoloration of aged finish.
METHOD OF APPLICATION: MIX THOROUGHLY BEFORE USING! Apply with brush, roll, spray, wiping
cloth or applicator pad. Do not apply below 50° F, if rain is anticipated with 48 hours or heavy dew is
present.
DIRECTIONS FOR USE: MIX THOROUGHLY BEFORE USING!
STAINED EFFECT: Apply a thin coat of approximately 300 sq.ft/gal. with brush, roll or applicator pad.
This should minimize sheen development especially on tight, non-absorbing wood grain. Remove excess
or puddled material that has not penetrated after 15 minutes with a paint pad or rags. See special
precaution for rag disposal.
GLOSS VARNISH LOOK: Apply a thin coat of approximately 400-500 sq.ft/gal., allow drying for 48 hours
or until firm and then applying a second thin coat.
DRY TIME: 48-96 hours depending on drying conditions. Drying conditions will vary greatly depending
on applied film thickness and weather conditions. Multi coat applications may be "tacky" for up to 30
days. Full cure will begin when surface is tack free. THINNING AND CLEANUP: No thinning required. Use
mineral spirits for equipment clean up.