User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
ORION® SE American® Residential Gas Meter Transmitter
ORION Installation Components for an American Meter
Figure 7: Installation Materials
4 Tamper Plugs
Front
Gasket
4 Screws
¼-20 X 3/8"
4 Screws
¼-20 X 3/8"
4 Screws
#8-16 X ½"
4 Screws
#8-16 X ½"
Cover
2 Screws #8-16 X ½"
OR
2 Screws #8-16 X ¼"
Index
From Existing Meter
Transmitter
Rear
Gasket
Page 10
(8-10)