User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
Installation Data
Index Installation
NOTE: There are two (2) index capacities, ONE FOOT and TWO FEET; and two index mounting styles, slots and holes.
Place screws in slotted index
1. Place two (2) #8 X ½" self-tapping screws between the top metal dial and the lower plastic frame and into the holes
on each side of the index.
Figure 13: Screw Placement in Index
Place screws in index with holes
1. Place two (2) #8 X ¼" self-tapping screws between the dial and lower plate and into the holes on each side of the
meter.
Figure 14: Screw Placement in Index (continued)
2 Screws
(8-10)
Page 13