User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
ORION® SE American® Residential Gas Meter Transmitter
Drive pawl engagement and installation of index
1. Use care when handling the Badger® ORION® transmitter and index to insure the transmitter rear drive pawl and the
mating drive pawls are not subjected to any physical abuse. Abuse may cause the spindles to become bent, mis-
aligned, or otherwise inoperative.
NOTE: When attaching an index to a Badger ORION transmitter, make sure the index mounts securely to the transmitter.
The front and rear drive pawls must mate without causing any binding or potential for disengagement.
2. Align the two (2) screws in the transmitter holes.
Figure 15: Screw Alignment
On a TWO FEET dial, engage the index drive pawl into the half round connection in the transmitter.
Figure 16: Two-feet Dial
Index Drive Pawl
Half Round Connection in Transmitter
Page 14
(8-10)