User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
ORION® SE American® Residential Gas Meter Transmitter
4. Test the drive pawl connection by turning the shaft on the rear of the transmitter several times. If dragging or friction
is felt, reposition the index to eliminate any drag. The dials should turn smoothly.
Figure 19: Test Pawl Connection
Final Assembly
Place the Transmitter and Index on an American® Gas Meter
1. Verify that the rear gasket does not interfere with the transmitter drive shaft.
2. Verify that the gasket ts around the semi-circular cut out guide.
Figure 20: Gasket Verification
Cut Out Guide
Transmitter
Drive Shaft
Rear Gasket
Page 16
(8-10)