User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
ORION® SE American® Residential Gas Meter Transmitter
Program the Transmitter
Badger® uses a handheld system to process and display screens.
Figure 27: Handheld Devices
Please reference the document ORI-IOM-40, Badger-Radix Installation Tool User Manual or ORI-IOM-52, Trimble Ranger Instal-
lation & Operation Manual.
Two programing procedures
There are two procedures to program the transmitter and index. One procedure involves reading the transmitter IR port with
the Radix handheld programmer/data collector. The other procedure involves reading the transmitter with an IR Read Head
attached to either a Radix or Trimble Ranger.
Figure 28: IR Port
Trimble
®
Ranger
™
and IR Read Head
and Cable
Radix
Transmitter IR port
Page 20
(8-10)