User's Manual
Table Of Contents
- DISCLAIMER
- QUESTIONS OR SERVICE ASSISTANCE
- PRODUCT IDENTIFICATION
- SCOPE OF MANUAL
- PRODUCT UNPACKING AND INSPECTION
- LICENSE REQUIREMENTS
- INSTALLATION TOOLS and MATERIALS
- INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
- AMERICAN® GAS METERS
- Index Removal From an American Gas Meter
- ORION Installation Components for an American Meter
- Assemble the ORION Transmitter and Index
- Place the Cover Over the Transmitter and Index
- Final Assembly
- Drive pawl engagement and installation of index
- Index Installation
- Place four (4) screws into the transmitter
- Program the Transmitter
- APPENDIX
Installation Data
INSTALLATION of BADGER ORION INTEGRAL TRANSMITTER and INDEX
This manual describes installing a Badger ORION transmitter and index on an American gas meter.
AMERICAN® GAS METERS
Gas Meter Mfg.
American Meter Gas Meter Models with prexes: AL, AC, AT, AM, AR and with suxes: 175, 210, 225, 250, 310, 350, 425, 630
American Gas Meter and Indexes before installation of new ORION Transmitter
Figure 1: Gas Meter with Odometer Index (top right) & Dial Index (bottom right)
Index Removal From an American Gas Meter
1. Use a large screwdriver to puncture and remove tamper plugs, if present.
Figure 2: Tamper Plugs (circled)
(8-10)
Page 7