User's Manual

ORION® SE Integral Endpoint for American® Residential Meters
ASSEMBLE THE ORION ENDPOINT AND INDEX
Endpoint Gaskets Attachment
The gaskets should be attached to the endpoint at the factory. If the gaskets are not attached:
1. Place the rear gasket on the back of the endpoint. Place the rear gasket so the tab is at the top of the endpoint, the
drain slots are pointing down, facing towards the gas meter.
Drain Slots Pointing Down
Drain Slots Towards Gas Meter
2. Place the front gasket on the other side of the endpoint.
• Place the gasket so that its two holes go over the two protruding tines.
• Be sure the notched end goes around the guide pin on the right side of the endpoint.
Holes Over Tines
Notched End Around Guide Pin on
Right of Endpoint
Tab on Top
Page 10
(1-11)