User's Manual

Installation Data
• Be certain that the stepped edge is toward the endpoint boot and seated between the endpoint sealing face and
the alignment tabs.
Place Four (4) Screws Into the Endpoint
1. Place the four (4) ¼-20 X 3/8" screws through the endpoint and rear gasket from the front.
2. The screws are temporarily held in place by the rear gasket.
Endpoint Sealing Face
Endpoint Boot
Stepped Edge
Alignment Tabs
Gasket Lip
Tab Up
Screws Held in Place
Drain Slots Facing Down and
Towards the Gas Meter
(1-11)
Page 11