User's Manual

ORION® SE Integral Endpoint for American® Residential Meters
3. Tighten the two (2) screws (6 in-lbs max).
4. Test the drive pawl connection by turning the shaft on the rear of the endpoint several times. If dragging or
friction is felt, reposition the index to eliminate any drag. The dials should turn smoothly.
PLACE THE ENDPOINT AND INDEX ON AN AMERICAN GAS METER
Verify that the rear gasket does not interfere with the endpoint drive shaft.
Verify that the gasket ts around the semi-circular cut out guide.
Testing the Drive
Pawl Connection
Rear Gasket
Endpoint
Drive Shaft
Cut Out Guide
Page 14
(1-11)