User's Manual

Page 57
12-10
Installation & Operation Manual
Note: When you change the value of this setting, you must exit the software and restart it.
- Default Zoom Level: A value of 250 will show 250 feet as 1 inch on the screen.
- Minor Road Cutoff Zoom Level: When zooming out past this value, only the major roads are visible.
• Map Orientation: Choose how the map is displayed while reading meters:
- North Orientation and Rotating Pointer: The map shows north at the top of the screen and the pointer
representing the vehicle will point in the current driving direction (the most common choice).
- North Orientation: The map always shows north at the top of the screen.
- Rotating Map: The top of the screen indicated the current driving direction; the map rotates as the vehicle turns
corners.
• Starting Location: This address (or latitude / longitude coordinates) will show on the map when you Start Reading
meters, until the GPS antenna reports the current location of the vehicle. From then on, the map will center at the
location of the vehicle.
• ORION Entry/Exit Zones: These distances specify when a endpoint is within range of the receiver, and when it
has moved out of range. If a endpoint was within range, and moved out of range without receiving a reading, that
endpoint is marked as MISSED.
• Other Entry/Exit Zones: These zones are used for reading technologies other than ORION.
• Newly Added to Map Sound: When geocoding and a new meter is added to the map, you will hear the selected
sound.