User's Manual

Installation Data
After the endpoint is mounted in the Remote Box Enclosure, loop the endpoint wire through the strain relief tab and through
the cut out on the bottom of the enclosure. If needed, gel splice connections can be made and kept inside the Enclosure prior
to mounting.
Figure 10: Endpoint Wire Positioning
To install, verify that the Remote Box Enclosure is properly positioned with the endpoint antenna up and the endpoint IR port
facing down and secure the enclosure to the wall using appropriate customer supplied screws.
Figure 11: Enclosure Positioning
Right Side
Strain Relief Tab
Cable out of
bottom
(12-10)
Page 11