User's Manual

Installation Data
REMOTE INSTALLATION
REMOTE BOX ENCLOSURE
The ORION Remote Box Enclosure is for use with either the Recordall® Transmitter Register (RTR®) or Absolute Digital Encoder
(ADE®) stepped tube and threaded tube ORION endpoint for remote mounting applications. The Remote Box Enclosure
is designed for mounting ORION endpoints in indoor or outdoor environments and also provides an environmentally
protected area for gel splice connections (if needed) to be maintained inside the enclosure.
Remote Box Enclosure
ORION Endpoint
Figure 7: Enclosure and Endpoint
The following ORION Remote Box Installation Kit (64394-021) is required to properly mount the ORION endpoint for remote
applications.
After obtaining the installation kit, the installer places the endpoint into the ORION Remote Box Enclosure. To ensure
maximum endpoint performance, it is important to mount the ORION endpoint in the proper orientation, with the endpoint
antenna up and ORION endpoint IR communication port and wire down.
To verify the proper orientation, ip the enclosure over and look inside the ORION Remote Box Enclosure. Locate the three
security ribs inside the Remote Box Enclosure to determine the top of the enclosure. The bottom of the Remote Box Enclo-
sure is identied by the two strain relief tabs located on both sides of the enclosure housing and the hole in the bottom of
the enclosure that allows access to the endpoint IR communication port without having to disassemble the unit (Figure 8 on
page 10).
(12-10)
Page 9