User's Manual

ORION® SE Network Gateway Transceiver
NOT:N Installation of banding mounting kit requires use of the BAND-IT tool shown below (66042-006) or equivalent
BAND-IT tool as recommended by BAND-IT.
Figure 7: BAND-IT Tool
1. Locate the BAND-IT tool and supplied installation instructions.
2. Follow the BAND-IT-supplied installation instructions enclosed with the BAND-IT tool for attaching the network
gateway transceiver to a pole.
3. Using a 1/2-inch wrench, apply the recommended torque for the 5/16-24 screw that attaches the network gateway
transceiver bracket to the BAND-IT banding. The recommended torque is 144…168 inch-pounds
(12…14 foot-pounds).
Figure 8: Network Gateway Transceiver Shown with BAND-IT Mounting Hardware
Page 10 June 2012