User's Manual

ORION® SE Network Gateway Transceiver
2. Strip the cable outer jacket to a maximum length of 1.1 inches.
Figure 11: Stripped Cable Wires
3. Shorten the foil shield ush with the outer jacket.
4. Strip the ends of the six (6) colored wires to a length of 1/8 inch. Twist the conductors on each wire.
5. Shorten the drain/bare wire (no insulation) to 11/16 inch.
6. Loosen the screws on the female insert and attach the wires to the female insert using the chart below. Retighten the
screws after each wire has been connected.
Wire Female insert connector
Slot
Red
1
2
3
4
5
7
8
Brown
Black
White
Green
8 (center) is for the shield-drain
M12 Connector Wire Contact View
Blue
White 4
Drain 8 (Center)
Black 3
Blue 7
Red 1
Green 5
Brown 2
7. Assemble the female insert to the coupling sleeve by aligning the female insert tab slot with the notch in the
coupling sleeve.
Figure 12: Slot Alignment
Female Insert
Tab Slot
Coupling Sleeve Insert
Notch
Page 12 June 2012