User's Manual

Installation & Operation Manual
Figure 13: Bottom of Network Gateway Transceiver (GPRS unit shown)
8. Remove the M12 cap from the M12 receptacle on the bottom of the network gateway transceiver and discard the
cap.
9. Connect the M12 plug connector assembly to the M12 receptacle and tighten the locking ring in a clockwise
direction until nger tight.
10. Connect the 308 connector on the other end of the power cable to the 308 connector of the AC-to-DC power supply
and snap the anti-tamper collar over the connection.
11. Connect the power cord to the power supply and then plug the three-prong male end of the power cord into a
120V AC power source.
M12 Cap Removed
Page 13 June 2012