User's Manual

Installation & Operation Manual
DC Power Source Installation
The ORION SE network gateway transceiver may be ordered with a 10-foot DC power source cable for direct connection with
a customer-supplied DC power source (24V DC @ 1A minimum). When connecting an AC-to-DC power supply, the electrical
requirement for the network gateway transceiver is 1 amp (minimum) at 24V DC. When connecting directly to batteries, as in a
solar assembly (not supplied), the minimum electrical requirement is 0.4 amp at 24V DC.
Figure 17: 10' DC Power Cable
NOT:N Consult the appropriate electrical, building and industry codes, regulations and standards for accepted installation
practices when attaching the cable to a DC power source.
DC Power Source
(customer supplied)
10-foot DC Power Source Cable
with 308 In-line Connector End
(supplied)
ORION SE Power Cable with
308 In-line Connector
(supplied)
Figure 18: DC Power Source Installation (* Shown with NEMA 4 enclosure.)
*The enclosure may be recommended but is not included.
External DC power source connections:
Wire Color for 66233-020 External DC Power Source
Drain (no insulation) Negative (–)
Black Negative (–)
Brown Negative (–)
Red Positive (+)
Light Blue Positive (+)
Page 17 June 2012