User's Manual

ORION® SE Network Gateway Transceiver
MOUNTING THE ORION SE NETWORK GATEWAY TRANSCEIVER
IMPORTANT
TRANSCEIVER INSTALLATION, MOUNTING AND DISPOSAL SHALL BE IN ACCORDANCE WITH ALL LOCAL, STATE AND
FEDERAL REGULATIONS. WHEN INSTALLING THE TRANSCEIVER, THE CUSTOMER IS RESPONSIBLE FOR COMPLYING WITH
LOCAL, STATE AND FEDERAL CODES AND GUIDELINES AS WELL AS APPLICABLE INDUSTRY STANDARDS, SUCH AS ANSI/
TIA/EIA 222 STRUCTURAL STANDARDS FOR STEEL ANTENNA TOWERS AND ANTENNA SUPPORTING STRUCTURES AND
THE NATIONAL ELECTRICAL CODE NEC. PROPER GROUNDING IS NECESSARY, AND IN THE CASE OF A WOODEN POLE, A
DEDICATED COPPER GROUND WIRE SHOULD BE USED FOR LIGHTNING PROTECTION.
Network Gateway Transceiver Standard Components
• Two removable whip antennas with O-rings. One GPRS and Wi-Fi backhaul antenna is included with GPRS and Wi-Fi
gateway units.
• One ORION SE network gateway transceiver with attached mounting backplate.
• V-block clamps or banding and locking equipment for attaching an ORION SE network gateway transceiver to a pole.
• 100-foot or 300-foot power cable, M12 connector, AC-to-DC power supply and power cord.
Figure 1: Transceiver Components (GPRS unit shown)
Antenna Receptacle
Transceiver Enclosure Cover
Antenna Receptacle
Backhaul Antenna
Type N Connector
Whip Antennas
GPRS or Wi-Fi Antenna
Page 6 June 2012