User's Manual

GALAXY® II Gateway Receiver
Banding Mounting
Banding mounting equipment is sized to mount the gateway on a 2-1/2…24-inch outer diameter pole.
IMPORTANT
When using the banding mounting kit for the network gateway receiver, use BAND-IT® Idex installation practices. Refer to
www.band-it-idex.com/en/Literature/Tool_Instructions/P05886.pdf for more information. This is especially applicable when
mounting on a non-tapered vertical pole, as the banding could loosen over time resulting in the unit sliding down the pole.
To mount the gateway on a pole, gather the banding and locking equipment.
Figure 8: Banding and locking equipment
OTE:N Installation of banding mounting kit requires use of the BAND-IT tool shown below (66042-006) or equivalent
BAND-IT tool as recommended by BAND-IT.
Figure 9: BAND-IT tool
Page 12 February 2014