User's Manual

ORION® SE II Network Gateway Transceiver
4. Attach the metal housing to the
RJ45 receptacle on the gateway:
• Remove the RJ45 receptacle
bayonet lock cap from the
gateway by turning the cap
1/4 turn counter clockwise.
OTE:N The RJ45 receptacle cap
should be saved so it can be
replaced if the Ethernet cable
is removed later.
• Place the metal housing on
the RJ45 receptacle and turn
it until you feel the metal
housing align with the keys
on the RJ45 receptacle
(Figure 33).
Once aligned, tighten the
outer sleeve on the metal
housing 1/4 turn clockwise.
OTE:N The metal housing fits on
the RJ45 receptacle correctly
when it is aligned with the
keys on the RJ45 receptacle.
Figure 32: Bayonet lock cap
Figure 33: Remove bayonet lock cap
5. Attach the half insulators to
the RJ45 modular plug on the
Ethernet cable connector:
• Hold down the plug latch and
slide one of the half insulators
over the latch. Make sure the
half insulator prong is aligned
next to the plug latch as
shown in Figure 35.
Figure 34: Plug latch
Figure 35: Half insulator over latch
• Slide the other half insulator
over the other side of the
latch while holding the half
insulator you just attached,
again making sure the
prong is aligned next to the
plug latch.
• Squeeze both insulators
together to connect. You
will hear a “click” when the
connection is made. The plug
with both half insulators is
shown in Figure 36.
Figure 36: Half insulators connected
RJ45 Receptacle Bayonet
Lock Cap
Page 28 October 2013