User's Manual

ORION® SE II Network Gateway Transceiver
Remote Antenna Installation Instructions
Remote antenna installations must be performed by a professional installation contractor to ensure compliance with
FCC regulations.
FAILURE TO READ AND FOLLOW THE INSTRUCTIONS PROVIDED CAN LEAD TO MISAPPLICATION OR MISUSE OF THE
ORION SE II NETWORK GATEWAY TRANSCEIVER, RESULTING IN PERSONAL INJURY AND DAMAGE TO THE EQUIPMENT.
1. Unpack the ORION SE gateway assembly from the
box. Locate and retain any accessories packaged
with the gateway.
OTE:N The GPRS backhaul antenna is not
connected when shipped.
2. For each TX/RX antenna, cut and remove the
cable ties holding the antenna cable to the
gateway enclosure.
Disconnect the TX/RX antenna cable/connector
assembly from connectors located on the enclosure
and base of each antenna (Figure 48).
Figure 47: Gateway assembly with GPRS antenna
Figure 48: Disconnect cables and connector assemblies
3. Remove the antenna cable/connector assemblies but retain for future use should direct connection of the antennas
be required in the future.
Page 38 October 2013