User's Manual

Installation Manual
4. Disconnect the enclosure from the backplate by
removing the two (2) locknuts from each side of
the enclosure (Figure 49). Retain the locknuts as
they will be used later to reattach the enclosure to
the backplate.
5. Carefully lift the enclosure o of the backplate using
caution to not damage the backhaul antenna cable.
Figure 49: Disconnect enclosure from backplate
6. There are three locknuts holding the TX/RX antenna
mounting bracket on the enclosure backplate (Figure
50). Remove those and separate the antenna bracket
and antennas from the enclosure backplate.
Figure 50: Remove antenna mounting bracket locknuts
7. Once the antenna mounting bracket is removed,
reattach the enclosure to the mounting backplate.
8. Attach the antenna bracket to the remote mounting
structure using either V-block mounting hardware
or Band-IT banding, depending on the structure.
The example shown in Figure 51 is using V-block
mounting hardware. A side view of the mounting
hardware is shown in Figure 52.
Figure 51: Antenna bracket attached with V-block mounting
hardware
Figure 52: V-block mounting hardware side view
Page 39 October 2013