User's Manual

ADE Endpoint
After the ADE is assembled to the meter and the ORION endpoint is installed, the endpoint is ready for operation. Using
a handheld or a mobile laptop conrms that the endpoint wiring has been done correctly and that the endpoint is
broadcasting RF data for reading. When allowing the endpoint to turn on via consumption, the endpoint requires two hourly
reading intervals where consumption has changed the electronic reading. For example, on a six-dial ADE, the ADE must
detect consumption of 10 gallons over two, separate hourly reading periods before the endpoint will begin broadcasting
read data. In either case, no specic testing or programming of the endpoint is required. Reading each pit endpoint after it
has been installed veries proper installation and reading performance.
ADE, ORION and RTR are registered trademarks of Badger Meter, Inc.
Other trademarks appearing in this document are the property of their respective entities.
© 2011 Badger Meter, Inc. All rights reserved.
Due to continuous research, product improvements and
enhancements, Badger Meter reserves the right to change
product or system specications without notice, except to the
extent an outstanding contractual obligation exists.
Badger Meter | P.O. Box 245036, Milwaukee, Wisconsin 53224-9536
800-876-3837 | [e-mail] | www.badgermeter.com