Installation Instructions

Cable Connector Procedure

Installation Instructions:

The following instructions are to assist you in the connection process if necessary. Keep all parts clean

prior to assembly. Any dirt or water within the connector enclosure can cause corrosion of the contacts

which will reduce connector life.

When connecting the components, ensure the terminal

cavity of the Male Connector contains an ample amount of

grease. The connectors should be shipped from the

factory with the appropriate quantity, but if the

connectors are being replaced or repaired, some volume of

grease may have been displaced. In that case, or if the

connector was inadvertently shipped without grease, then

before connecting first apply grease from the small tube

in the kit into the terminal cavity for the male

connector. The tube contains the correct quantity of

grease to use, so be sure to dispense all of it into the

connector. A pliers may be helpful to assist in

squeezing out the last quantity of grease.

1. Drop the Lock Band onto the Female Connector with the Short Alignment Mark up and position the

band so that the Long Alignment Mark is lined up with the Alignment Mark at the base of the Female

Connector.

2. Insert the Male Connector into the female connector, again lining up the Long Alignment Marks on

each component. The insertion operation may require significant force to displace the excess grease

from the connector cavity.

3. With the connector halves forced together, turn the locking band to align its Short Alignment Mark

with the Long Alignment Marks on the connector halves. It may require a pliers to rotate the band to

its final position. A clicking sound should be heard when the band achieves its final and correct

position.

FCC ID: GIF4545

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation

!WARNING!

Any modifications to the unit, unless expressly approved by the party responsible

for compliance, could void the user’s authority to operate the equipment.