Manual

Operation Modes
The configuration of the system is generally done by using the PC-based FMS Software. Only some special functions like the
operation modes are set at the Master Keypad.
RF System with PC Operation Mode
In this mode the PC is used to configure the system entities and install the network. The PC will be used to enter work orders
for processing and provide the queuing for future processing. When an operator processes a work order the PC will validate
the work order number and provide the fluid and amount to be dispensed. The results of the dispense will then be stored on
the PC.
RF System with Host Operation Mode
In this mode the PC is used to configure the system entities and install the network.
The host will be used to enter work orders for processing and provide the queuing for future processing. It will also store
the dispense results that have been completed. Dispense results can be additionally stored on the PC. When an operator
processes a work order the host will validate the work order number and provide the fluid and amount to be dispensed.
Standalone Mode
Work orders will not be validated; each entered work order will be accepted by the system. Data will be stored in the Master
Keypad’s memory.
OTE:N Each meter can only be associated to one Dispense Keypad. Only dispense and keypad supervisors can access each
of the Dispense Keypads.
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 10 July 2014