Manual

Work Order Validation
WO validation is used to define if a work order shall be validated by the system before processing it.
Host Validation (Host Operation Mode)
In this mode the work order number will be sent to the ERP (DMS) system. Only after validation from the system the meter will
unlock. Afterwards the dispense data will be sent to the ERP system.
WO Valid. HOST
YES / NO
1. Use the Scroll key to move the cursor to either YES or NO.
2. Press ENTER.
PC Validation (PC Operation Mode)
In this mode the work order number will be sent to the PC (FMS Software). Only after validation from the PC will the order
number is accepted.
WO Valid. PC
YES / NO
1. Use the SCROLL key to move the cursor to either YES or NO.
2. Press ENTER.
WO Archive (Printout or Storing of the Work Order /Dispense Results)
WO archived
None Mem Print
1. Use the SCROLL key to move the cursor to your selection.
2. Press ENTER.
Mem Data stored in an optional memory module.
Print After each dispense, the data will be printed out on the
external printer.
Each line displays one dispense.
Archive on PC (Archive of the Work Orders/Dispenses)
Archive on PC ?
YES / NO
1. Use the SCROLL key to move the cursor to either YES or NO.
2. Press ENTER.
All dispense results are stored on the PC (FMS Software). If the PC is currently not available, the data will be tagged as “not
sent” in the memory of the master. The data will be sent as soon as the PC is connected again.
User Manual
Page 13 July 2014