Manual

DISPENSE KEYPAD
The Dispense Keypads are responsible for the communication with the RF meters. The user starts a work order from the
keypad. After the dispense operation has been completed the keypad will receive the actual amount dispensed from the
meter. The Dispense Keypad then sends the dispense results to the Master Keypad.
The system can handle up to 36 Dispense Keypads. Up to 24 meters can be assigned to each keypad but each meter can only
be assigned to one Dispense Keypad.
System Version Screen
V3.00 2.4 GHz
The standard screen shows the system software version number. The
display will alternate between the standard screen and the Enter Pin
Number screen. The Enter Pin Number screen is used to access the
supervisor menus.
V3.00 2.4 GHz
N
OTE:N An "N" displayed in the lower left-hand corner of the system
version screen indicates a Radio Network error. See “Radio
Status” on page 23 to check the source of the error.
V3.00 2.4 GHz
M
OTE:N An "M" displayed in the lower left-hand corner of the system
version screen indicates that the Dispense Keypad has joined
an RF network, but cannot currently contact the Master
Keypad for WO authorization.
V3.00 2.4 GHz
O
OTE:N An "O" displayed in the lower left-hand corner of the system
version screen indicates that the Dispense Keypad is in System
Override mode. See “System Override (SYS) Menu” on page 24
for details.
Enter Pin No.
- - - -
Enter a user PIN to start a work order or the supervisor PIN to enter the
supervisor menus (the default PIN is 0001).
Settings Overview / Supervisor Menus
The following configuration options are only available at the Dispense Keypad.
The default value for the Supervisor PIN is 0001.
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 18 July 2014