Manual

Meter Selection
Enter a preset meter (hose) ID for the product.
Enter Hose
- - -
5. Enter a preset meter (hose) ID for the uid product you want and
press ENTER.
• Only meters that are assigned to the current keypad can be selected.
• In the operation modes WO Validation HOST or WO Validation PC the system will check if the product you entered is assigned to this work
order.
Display Fluid
Fluid
Product Name
6. The chosen fluid type is displayed for three seconds.
Product Quantity
Quantity
----
7. Enter the desired quantity and press ENTER.
Optionally, the quantity assigned to this WO is shown.
• The quantity can be chosen between 0.0…99.9 and 100…999 units of measure.
• The preselection can be made with one decimal place.
• For quantities more than 100 units of measure, the meter counts down toward zero.
• A quantity of 0.0 will deactivate the preselection on the RF meter. The RF meter will not latch and the user is required to hold the
trigger in the open position to dispense fluid. The user must press RESET on the RF meter to complete the dispense operation and
communicate the dispense order result to the keypad.
Dispense Confirmation
Enter for
Dispense
8. Press ENTER to dispense the uid.
The work order is now ready for being picked up by the RF meter (see
RF Mode, Standard Preselection Mode) .
User Manual
Page 27 July 2014