Manual

RF Mode (Standard Pre-Selection Mode)
Work Order Validation via the Dispense Keypad
0.00
L
7.2
Dispensed
Quantity
RF COMBatch Size
When the battery pack is attached to the meter, the meter will
automatically enter the RF mode. The trigger is in a locked-out
position and no oil can be dispensed until a dispense order is
received by the meter.
1. Press the RESET button on the meter to enable it to receive a dispense order provided by the Dispense Keypad. The trigger
will unlock.
2. Pull the trigger to begin the dispensing of uid. The valve will automatically lock in place, even though the trigger will fall
back to the closed position. The ow will automatically shut o when the programmed amount has been dispensed.
3. To top o, pull the trigger to dispense uid and release when the desired amount has been reached.
4. Press the RESET button when nished. The total quantity will be transmitted to the keypad and the meter will return to a
locked-out position. The meter is now ready to receive the next dispense order from the keypad.
10 sec
02
Result stored in
Dispense Keypad
Preselection: Pull the trigger until it
latches and RELEASE the trigger.
No preselection (0 liter): Pull and HOLD
the trigger. The trigger won´t latch.
Press the
RESET button
Press the
RESET button
The red button will STOP
a dispense at any time.
Order stored in
Dispense Keypad
10 sec
02
CLACK
02
User Manual
Page 29 July 2014