Manualshelf

Manual

ManualsBrandsBadger Meter ManualsAccessories for waterFluid Management System
21222324252627282930
AUTO Mode (Autonomous)
MPORTANTI
This function allows unauthorized dispenses. The dispense information will not be associated to any mechanic or operator.
• The total dispensed quantity will be stored under the general work order number (999999).
• The AUTO sign at the display’s lower left corner indicates the manual mode.
Enter the AUTO Mode
To enter the AUTO Mode:
1. Press and hold the TOTAL button.
2. Press the following buttons one after the other: 10, 1, 0.1, AUTO.
You can use this same button sequence to return to RF mode.
The solenoid will now unlock and the meter may be used as a normal preselection meter.
3. Press the AUTO button to enter the preselection.
Reset to Standard Mode
To return the meter to the standard preselection mode, press the RESET button and start a communication with the assigned
dispense (see “Network Connect (CON) Menu” on page 24 and “RF Mode (Standard Pre-Selection Mode)” on page 29.
If the communication was successful (no “F02” error code) the meter will lockout and fall back in the preselection mode. The
total quantity, which has been dispensed during the AUTO mode, will be automatically transmitted to the Master Keypad. It
will be assigned to Misc. WO-Number (default 999999), with the user named as “???”. The dispense result will be marked with
the Status 16 for manual dispense.
Electrical Override
In case of an emergency or to interrupt a batch, the meter is equipped with an electrical override. This option automatically
closes the valve in the meter, stopping the flow immediately. The display will begin to flash because the meter does not sense
any flow. Batching can be continued after an override, even if the meter is in the middle of a programmed batch and the
display continues to flash.
1. Press the red SHUTOFF button to activate the electrical override. This button can only be used when the valve is open.
2. Press the RESET button to cue up the next batch and stop the display from ashing.
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 30 July 2014