Manual

Tanks and Fluids
Viewing Tank Status
To view the status of tanks in your system:
1. Click the TANKS & FLUIDS button.
2. View the current status and information.
To add fluid:
The information displayed includes:
• The tank ID
• Type of fluid in that tank
• Current level of the tank
• Total capacity of the tank
Adding Fluid to a Tank
If this feature is enabled, you can add fluid upon delivery.
To add fluid to a tank:
1. Double-click on the tank or select the tank
and click on FLUID DELIVERY.
2. Select the unit of measure the uid will be
delivered in (gallons, quarts, liters, or pints).
3. Enter the amount (in the selected units) of
fluid that is being delivered.
4. Click SAVE to save your changes or click
CANCEL to discard your changes.
5. Click OK on the verification screen to proceed,
or click CANCEL to edit.
If you enter an amount that brings the tank over
the capacity amount, the tank will appear in a red
“Warning” state until the proper amount of fluid is
removed via work order or the administrator goes
into the software and manually adjusts the level
of the tank.
Only the system administrator can correct a
tank level.
To exit the software, click the EXIT button.
When tank level warnings are enabled and a
fluid dispense causes the tank level to hit the
warning level, a message will appear on all part
department users screen. Click OK to clear the
message.
To exit the software, click the EXIT button.
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 52 July 2014