User Manual

Fluid Management System Standalone Keypad
Hose Address Already Used
Hose Address
Already Used
This screen displays if another RF Meter/Hose already uses the same
prefix and address. If this screen displays, check the RF Meters in the
system to make sure duplicate RF Meters do not exist. Then check to
see if this RF Meter/Hose has already been created in the system.
The message displays for 3 seconds then returns to Create Hose screen.
Deleting an RF Meter/Hose
The supervisor has the option to delete an RF Meter/Hose through this screen. This is necessary when there is a change to the
system or when an RF Meter/Hose needs replacement for any reason.
The supervisor should delete from the keypad the removed RF Meter/Hose prior to creating a new RF Meter/Hose. This puts
the new RF Meter/Hose in the same logical position with the keypad and the dispense order process remaining the same.
Delete Hose
YES / NO
1. Use the Scroll key to move the cursor to select YES.
2. Press Enter to advance to the Hose Prex screen.
Hose Prefix
xx:xx:xx:xx
3. Type the Hose Prex and press Enter.
Hose Address
-.---.---.---
4. Type the Hose Address and press Enter.
Pressing the Enter key with no entry displays the New Operator screen.
5. The screen displays the Hose ID of the deleted RF Meter/Hose.
Adding and Deleting Operators
• Only an operator with a valid PIN can dispense fluid.
• A maximum of 49 operators may be active in the system at one time.
• The operator ID (PIN number) format is 4 numeric digits.
• The operator name format is 16 alphanumeric digits. Initially, the operator list is empty.
Adding an Operator
The New Operator screen displays if you press the Enter key when there is no entry.
New operator
----
1. Type in the operator's 4 digit ID PIN number and press Enter to add
it to the list.
2. Type in the operator's name using the keypad and then press Enter
to add it.
3. Repeat steps 1 and 2 to add more operators.
4. When finished adding operators, press Enter while New Operator is
blank.
Deleting an Operator
The Delete Operator screen displays if you press the Enter key when there is no entry.
Delete operator
----
1. Type in the operator's 4 digit ID PIN number and press Enter to
delete it from the list.
2. Repeat step 1 to delete more operators.
3. When finished deleting operators, press Enter while Delete
Operator is blank.
Page 14 August 2012