User's Manual Part 1

THE READALL INTERROGATOR User Guide
Revised January 2001
Page 55 of 62
When you press the Program button, the ReadAll will send the programming
transmission to the transponder. The ReadAll will interrogate the transponder to verify
that the programming was successful and will then display the results of the
programming.
Note that if you are programming Gen 2 transponders, you must first place the
programming stick in its spot to do the programming step, and then remove the stick in
order to do the verifying read. The software will prompt you for these steps.
When you have recorded the results that you choose, press the touch screen anywhere.
The ReadAll will display the read screen for this meter. You are now ready to proceed to
the next meter requiring programming.
Programming using a Computerized Work Order System or Work Order Sheets
Because the Work Order system or the work order forms hold all the information
required for installation, the ReadAll is only used to program the transponder. No
information is loaded into the ReadAll before programming any transponders.
Be sure to prepare each transponder to receive the programming transmission by using
either the magnet or the special jumper. Please consult the technical brief for your model
of transponder for the exact procedure for preparing the transponder to be programmed.
When you are ready to program a transponder, press Read / Program Meters from the
ReadAll Main Menu. Because no meters are loaded, the ReadAll will ask you if you
wish to see the Read Menu. The screen looks like this.