User's Manual Part 1

THE READALL INTERROGATOR User Guide
Revised January 2001
Page 60 of 62
For transponders you have just received or are ready to install, each of the IDs is bar
coded on a label on the outside of the box. Using the optional bar code scanner
connected to the serial port, the ReadAll will accept the transponder ID from the scanner
and immediately interrogate the transponder and display the results.
To use the bar code scanner to enter the transponder ID numbers, touch the center of the
box marked Scan Serial Number to place an “X” in the box. When an “X” is marked in
the box, the Quick Read will receive the transponder ID number via the serial port from
the bar code scanner, interrogate the given transponder, and display the results. To read
the next transponder ID, read the next bar code. When you are done reading the bar code
labels, clear the “X” from the Scan Serial Number box.
You can use the bar code scanner to verify that transponders you have just been shipped
are operating. Just follow this simple procedure.
• Display the ReadAll TRACE Quick Read screen
• Connect the bar code scanner to the ReadAll’s serial port and check the Scan
Serial Number box
• Read the transponder number from the bar code on the side of the shipping box by
squeezing the trigger on the bar code reader while lining the scan line on the bar
code you want to readThe ReadAll will perform the quick read and display one of
these results:
o The reading will be displayed in the reading box, and the successful audio
tones will be sounded
o The tamper status will be displayed in the reading box and the tamper
audio tones will be sounded.
• No Response will be displayed in the reading box and the no response
audio tones will be sounded.