User's Manual
Table Of Contents
- Introduction
- Glossary
- Trimble Ranger Handheld Overview
- Conserving the Battery
- Charging the Handheld Battery
- Handheld Setup for Reading Both ORION ME and ORION CE Endpoints
- Handheld Basic Operations
- Swapping the Battery Pack (Low Battery)
- General Care of the Handheld
- Using the Touch Screen
- Program Startup
- Copyright Screen
- Main Menu
- Reading a Route
- Manual Reads
- Read Results
- Read Menu
- Comments
- Read Direction
- View High/Low
- Manual Read
- _
- Utilities
- Route Info
- Program & Quick Read
- ORION CE
- ORION ME/SE Utility
- Utilities
- PROGRAMMING AN ORION GAS MODULE
- Appendix
- Using the Handheld Keypad
- Hot Keys and Quick Keys
- Technical Support
Page 41
1-12
Installation & Operation Manual
Settings
The COM (communication) ports for the reading technology are displayed on the Settings tab of the ORION CE Utility.
Figure 43: ORION CE COM Settings
• IR COM port - connected using the serial port (COM 1) at the bottom of the handheld
• RF COM port - built in to the handheld (COM 7)
Standard settings are shown above. Adjust the COM ports using the up and down arrows. When the COM ports are adjusted
correctly, tap Save.
Note: Adjustments to the COM ports should be made only under the direction of Badger Meter Technical Support.
About
The About tab displays information about the current version of the Quick Read software.
Figure 44: Software Information