User's Manual
Table Of Contents
- Introduction
- Glossary
- Trimble Ranger Handheld Overview
- Conserving the Battery
- Charging the Handheld Battery
- Handheld Setup for Reading Both ORION ME and ORION CE Endpoints
- Handheld Basic Operations
- Swapping the Battery Pack (Low Battery)
- General Care of the Handheld
- Using the Touch Screen
- Program Startup
- Copyright Screen
- Main Menu
- Reading a Route
- Manual Reads
- Read Results
- Read Menu
- Comments
- Read Direction
- View High/Low
- Manual Read
- _
- Utilities
- Route Info
- Program & Quick Read
- ORION CE
- ORION ME/SE Utility
- Utilities
- PROGRAMMING AN ORION GAS MODULE
- Appendix
- Using the Handheld Keypad
- Hot Keys and Quick Keys
- Technical Support
Page 49
1-12
Installation & Operation Manual
Settings
The COM (communications) Ports for any hardware attached to the handheld are displayed on the Settings screen. The
ORION ME transceiver version number is also displayed. Before reading meters for the first time, check the Settings to ensure
the correct COM Ports are set for the the hardware connected to the handheld to establish communication with the software.
1. Tap the Settings tab to access the IR and RF COM
Ports on the handheld.
2. Tap in the COM Port eld and make changes
using the keypad.
3. Tap Save to save any changes. Tap Close to exit
the screen without saving changes.
Note: Adjustments to the COM ports should be made
only under the direction of Badger Meter Technical
Support.
Figure 60: COM Ports